MCU: AT32F435RGT7, 288MHz, 384kB RAM, 1MB Flash
IMU: QMI8658A (SPI2)
Baro: BMP280 (I2C2)
OSD: AT7456E (SPI1)
Blackbox: Flash memory 128MBit (SPI1)
8x UARTs (1,2,3,4,5,6,7,8)
8x PWM outputs(including “LED” pad)
2x I2C
5x ADC (BAT1, CU1, RSSI, VESC2, CU2)
3x LEDs Статусы ПК(Yellow, Blue, Orange)
1x LED Индикатор 5.0V(Red)
USB Type-C (USB2.0)
1x JST-SH1.0_8pin connector (BAT1/G/CU1/RX/M1/M2/M3/M4)
1x JST-SH1.0_8pin connector (VESC2/G/CU2/RX/M5/M6/M7/M8)
Поддержка двух камер
DJI FPV OSD доступно на любом UART

Питание:
Vbat Input: 6~36V (2~8S LiPo)
BEC: 5V 2A cont.
BEC: 9V 2A cont.
LDO 3.3V: Max.200mA
LDO (IMU) 3.3V: Max.200mA
No Current Sensor built-in
ADC VESC2 pad supports Max. 69V (voltage divider: 1K:20K)
Потребление: 200mA@5V(Betaflight), 150mA@5V(ArduPilot)